Maribel Matthews Table Lamp November 02nd, 2018 - 03:32:49
The table lamp saw, and I did this on all four sides. I measured and marked about two and a half inches from the end of the block on each side, and I centered that mark - and I did this on both the top on the bottom of my blog. So you need to make two holes using a 35-millimeter foster base. Now one of the holes has to be almost all the way through, but not quite so use your desktop of it once you've been your first hole flip that bluff over to make the second hole, and this one is all the way through.
So this is what it should look like when you're done as you can see, we're missing one hole there and that'll be for the toggle switch and we're going to use a 1/2 inch Spade fit to make that hole. The last hole you need to make is using a 3/8 drill bit and this will be to pass the wire through into the base, I'm using a fabric covered extension cord for this project. All you have to do is cut off one end and you're good to go.
So what's inferred to note that there are two different wires in the extension cord. There is a smooth wire and that's the hot wire, while the other one is ribbed and that's your future wire so start by taking the hot wire and connect that to one of the leads from the toggle switch next connect, the other lead from the toggle switch to the black wire of the lash out and finally connect a white wire from the last socket back to the neutral ribbed wire.
Copyright © 2019 marcosvillatoro.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Floor Lamps 8 inch wall clock bathroom vanity string lights soap dispenser toilet seat warmer rocking chair square tablecloth best bathroom sinks tablecloth outdoor light best armchair.